Hello, I'm using a Habitat C7 that I updated to a year ago during the Christmas sale. I was previously on a C3. The problem is that the GE Smart Switches (2) (Z-Wave Plus) do not update their status (on, off) if the physical switch / button (on or off) is pressed. This was never an issue on the for…

The switches say plus in the side, but as noted in my original post, I tried all the possible drivers

It’s currently on Generic Z-Wave Smart Switch which was the last driver I used before I posted

I also just hit configure and saved and still no status change

Thing is, I was involved with the founders of Hubitat and started the Hubitat FB group that is now their official group since shortly afterwards the first year, so I’m definitely familiar with all of this. Again, they used to work fine till the c7 upgrade last year. Then I just kept ignoring the iss…

Might be a firmware update available that helps..? [image] GE/Jasco firmwares available! Built-in Drivers Maybe I’m late to the party, but: firmware/zwave/Enbrighten-GE at main · jascoproducts/firmware · GitHub

[image] bobstrenger: I pulled the switch to verify the exact model. GE ZW4001 Sounds like Z-Wave+ to me, but the behaviour would make non-plus such an obvious easy answer. Just for fun, could you post the data from the device page? Or just check that you have 0x5E as shown? [image]

only 0x25, or is 0x5E listed anywhere in that list (I'm not positive they're listed in the same order for all devices). 0x5E signifies Zwave Plus.

Here’s the whole string: inClusters: 0x25,0x27,0x73,0x70,0x86,0x72,0x77

GE Z-Wave Plus Smart Switch not updating status when physical button is pressed

Get Help

velvetfoot December 7, 2023, 9:19pm 11

It seems to be pre Z-wave plus and supposedly, according to the thread below, they were hit or miss on whether they reported on physical. @jasonjoel would know.