While waiting (or I guess, technically, not waiting), I installed the drivers from
... and I excluded, factory reset, and included one switch and one dimmer (without selecting S2 unauthenticated). They now both have more clusters and the firmware shows as 4.0 instead of no value visible.
What are the zwaveassociationG values?
I returned to my motion sensor switching rule to see if that helped, but found that the rule was still not turning the light on (and then it would seem to lock up and not respond to physical or digital on attempts).
The rule I was trying had a "Set dimmer level per mode" action in it. After restarting the hub, so the switch would respond again, I revised the rule to just a Switch On action. Then the rule worked.
So my additional question @agnes.zooz is whether this means the ZEN22 cannot handle the "Set dimmer level per mode" action, or for anyone else - could it be the driver and the fact @bcopeland wrote it for firmware 3.7 and my dimmer is already at 4.0 (or something else I'm totally missing)?
