I got my Uni setup yesterday with the Shelly app, but haven't been able to add it as a device in Hubitat. I've tried creating it using @tomw drivers, but Hubitat gives and error and won't save it as a device.
Do you think this pressure reading (level translating) probe would work and survive in a heavily silted, often dry, sometimes algae'd, water application ?
Tim
You are trying to install a package manifest as a driver.
This is not the driver code @tomw do you have a direct url for your uni driver that Tim can install from?
I will suggest HPM though- it's a lot easier to install in one step using the single URL than to tediously install each of these. But either way should work.
Thanks much @tomw and @Cobra, that really helped. I got the Hubitat Package Manager installed and the Shelly drivers and devices installed. Now I need to figure out how to configure the Shelly Uni.
Create a Virtual Device of type Shelly UNI. Then enter your Shelly IP address and save. That should establish communication with your Uni and create all of the necessary child devices.
I figured out why I couldn't configure the Shelly Uni on the configuration page. I put in the IP address as http:// 192.168.50.202/, which didn't work. So, I changed it to 192.168.50.202 and it started working and gave all the child devices.
Then I configured the "Shelly Uni for Reef Tank-adc0" to read the correct voltage, since the default voltage offset was -0.4 volts. I changed it to "-0.0" and it worked.
I was then able to create an alert app that sends a notification to my phone. Although, a tricky part was I had to use "Custom Attribute" as the capability of the Trigger event
One more question. I haven't been able to add the Shelly Uni to my Dashboard to monitor voltage, since it doesn't show up as a device in the "Add A Tile" Pick A Device drop down menu.
Could it be that the Shelly Uni was created as a virtual device?
Also, for anyone trying to add a Shelly Uni tile with Voltage, I had to pick the "Attribute" Template and then select Voltage from the Pick an Attribute pull-down.
sure it helps a lot,thank you very much for your clear informative reply,
much appreciated.
have another question please.
when i add the UNI as device it show me in the Type several options like Shelly UNI,Shelly child device,Shelly Common,,,
which one i choose?
thanks a lot
very helpful team here . thanks for sharing this driver for UNI. tomw great job.
is there a way to add to your UNI driver a water tank level Tile on Hubitat ?
which covert the voltage signal coming from UNI to water/liquid level animation? so we can use Uni to measure tanks level. example this sensor read 0-5 0r 0-10 volts .compatible with UNI.
it would great.
great vedio, WE SMART channel is my favorite .
I could add UNI to Hubitat by following your instructions.
it gave me voltage measurment on the Tile same like Shelly app.
what iam looking for now is how to make a tank animation Tile on Hubitat to be friendly user for my familly to see tank level without calculating the Uni Volts.
if you reach any idea please share.