Ahh...should've waited 10mins (or longer?). So it was a short-attention-span user error. (Should have done a little more research on SmartStart and maybe I would've found the "within 10 minutes" in the Z-Wave Manual | Hubitat Documentation and maybe also SmartStart How long does it take? and What is the point of zwave smart start?.)
I am attaching my Z-Wave Detail Devices Table and Topology and you will see the lock is device 0X68. It must have been 'mid-add' and in Z-Wave details but not in devices until I clicked on it in step 8 above.
So now...
-
should I remove the device and re-add? or just continue?
-
Any other thoughts on my Z-wave mesh? (you will notice two Zooz devices 0X12, 0X14 which I have powered down because they weren't working correctly, and I haven't had a chance to work on them).
-
Driver thoughts? Use Generic driver? another Schlage model? hope for Hubitat to make an official for J-Series? is there a community driver? (my search didn't yield one).
-
Also, how do I tell if a device or repeater is "beaming"?
Thanks again community!
