Release 2.3.8.122 Available
Changes from 2.3.8.120
Bug Fixes
- Likely fix for reported main hub process freezes after software update.
- Room Lights: Fixed turning off a light that reports off when Force is checked.
Change from 2.3.8.117 for C-7 hubs only!
If you are unable to update Z-Wave firmware on Z-Wave Details page, check out this post.
Starting with this release, an update is available for the Z/IP Gateway SDK to install version 7.18.03. To run the update, please go to the following end point:
yourHubIP*/hub/advanced/installZipgateway718
*replace yourHubIP * with actual IP address as assigned to your Hubitat Elevation hub.
If you have previously installed the Z-Wave firmware version 7.18.1 that was made available to all hubs on November 2022 with update 2.3.4, then no additional steps are required.
If the Z-Wave firmware update is still available for your hub, and you see Update Firmware button on the Z-Wave Details page, then select the Update Firmware button, first, before installing the Z/IP Gateway SDK update!
To confirm current Z-Wave versions that your hub is running, go to:
yourHubIP*/hub/zwaveVersion
If your results match the following details, no further actions are needed:
VersionReport(zWaveLibraryType:7, zWaveProtocolVersion:7, zWaveProtocolSubVersion:18, firmware0Version:7, firmware0SubVersion:18, hardwareVersion:1, firmwareTargets:1, targetVersions:[[target:1, version:7, subVersion:18]])
