danabw
March 16, 2021, 4:16pm
2
I haven't seen this. Which driver are you using? I use @JasonJoel 's excellent Enbrighten drivers w/my Jasco/GE/Honeywell/UltraPro Z-Wave Plus switches. Great drivers. Though - state change should work w/those switches w/the built-in drivers just fine.
GE Enbrighten Z-Wave Plus Dimmer Driver
The new GE Enbrighten devices are just different enough from the old that I wanted to make a new driver that supported the features correctly.
NOTE: This is for the toggle/paddle GE Enbrighten Z-Wave Plus Dimmers only (ZW3010 / 46203 / 46564). It will not work with any non Z-Wave Plus GE models (12xxx), it will not work correctly with any other Z-Wave Plus GE models (14xxx).
Features:
ON/OFF/Level
Can set default ON %, both by a parameter setting and …
GE Enbrighten Z-Wave Plus Switch Driver
The new GE Enbrighten devices are just different enough from the old that I wanted to make a new driver that supported the features correctly.
NOTE: This driver is designed to work with the 4xxxx series GE Enbrighten Z-Wave Plus Switches only. It will not work with any non Z-Wave Plus GE models (12xxx), it will not work correctly with any other Z-Wave Plus GE models (14xxx).
Features:
ON/OFF
Support for button events:
Single Tap Up = Button 1
Single …
1 Like
