Might want to take a look at one of the user drivers. I know mine shouldn't do that, as I was careful to take the dimming speed into account with the level & OFF reporting.
If it is the non-quick fit / shallow mount verson then:
GE/Jasco Z-Wave Plus Dimmer Driver
I got tired of the generic built-in driver missing features that are on the GE/Jasco dimmers. This was derived from the ST device handler, but mostly re-written at this point as there were a number of problems with the one I started with.
NOTE 1: This is for the toggle/paddle GE/Jasco Z-Wave Plus Dimmers only. It will not work with the non Z-Wave Plus models (12xxx), it will not work with any non-dimmer model, and it will not work with the Motion Dimmer (2693…
If it is the new quick fit/shallow mount then it would be:
GE Enbrighten Z-Wave Plus Dimmer Driver
The new GE Enbrighten devices are just different enough from the old that I wanted to make a new driver that supported the features correctly.
NOTE: This is for the toggle/paddle GE Enbrighten Z-Wave Plus Dimmers only (ZW3010 / 46203 / 46564). It will not work with any non Z-Wave Plus GE models (12xxx), it will not work correctly with any other Z-Wave Plus GE models (14xxx).
Features:
ON/OFF/Level
Can set default ON %, both by a parameter setting and …
