For anyone browsing the internet who is still having trouble pairing this thing, the problem for me was 100% the motion sensor. I was able to get them to pair, but like a lot of posts I saw the keypad would receive HSM events but didn't seem to want to send anything to the Hubitat. My process for pairing was:
- Remove from ZWave network by excluding on hub, and unplugging and pushing reset button on back of keypad once.
- Factory Reset Keypad (Hold reset button on back of keypad for ten seconds until blinking wireless icon turns red)
- Face keypad down on table to prevent any triggering of the motion sensor.
- If you haven't already, install the community driver as referenced in this thread
- Add keypad back to Zwave network using SmartStart, all default settings
a. If you're unfamiliar with SmartStart, its exclusive to the app(not the web GUI). A quick Google Search should get you up to speed on how to use it. - Once paired(The keypad will announce "Disarmed" once the pairing is complete), immediately swap over to the community driver.
- Disable the motion sensor, click save and then hit configure. The keypad should again announce "Disarmed"
- Configure your keypad as you want, from here you should be able to move the device to its permanent location and it should work as intended.
It was step 3 that really got things working for me. I highly recommend making sure that the motion detector doesn't go off until you can get it disabled in step 7. Hope this helps someone in the future!
