Rxich
June 26, 2024, 4:21am
14
If you serach/read through the forums you'll see an unresolved issue where non Zigbee 3.0 devices will migrate fine to the C8 but if they disconnect, then re-pairing them is very difficult, maybe impossible, unless the issue is addressed. Mike is working with Silabs to evaluate if it's fixable. Mike is incredible, Silabs...meh
Hello community,
I bought brand new Hubitat C8 and two sensors (Sonoff SNZB-02 and SNZB-03). When I try to pair those sensors (I was trying only one at once) via "Add Device", Hubitat finds out devices, but it stuck in "Found a Zigbee device, initializing...", after a minute or so it says "Found a Zigbee device, still initializing, please wait..." and then fails. The same issue occurs for both sensors.
In the Hubitat logs I see the following:
Zigbee Discovery Running
Initializing Zigbee Devi…
I'm having trouble pairing Zigbee devices with the C8. The C8 sees the device trying to pair, but it doesn't complete the process. Any ideas? The C8 has been running solid since yesterday.
[image]
[image]
[image]
[image]
I was an early adopter of the C8, but I migrated so never had to actually pair devices. Over this weekend because of various issues, I tore down my mesh and nuked my hub. Adding back the Zwave stuff was easy, but dang these Zigbee devices are just a pain in the butt. They get discovered but never fully initialized. I’ll go through it ten times or more before I may go through, My hue motion sensors never did. Ended up putting them on my hue hub through coco hue. Am I the only one with these zigbe…
and many other discussions
