I picked up a half dozen GE Enbrighten 46204 Smart Dimmer switches from closeout in a blue big box store and I would like to use them as standard on/of switches. As many of these will be controlling non-dimmable fixtures, I am looking for a simple driver etc. that will operate these at 0% to 100% w…

https://products.z-wavealliance.org/products/3352/configs Looks like Parameter 16 will do this for you. So pair the device normally, then change the driver to use the Basic ZWave Tool, configure Parameter 16 (size 1, value 1), and then change the driver back.

Hubitat

Using a GE Dimmer as a Switch

Get Help

remove

672southmain February 11, 2021, 2:49pm 3

[RELEASE] GE 4xxxx / ZW3010 Enbrighten Z-Wave Plus Dimmer Driver ⚙️ Custom Apps and Drivers

GE Enbrighten Z-Wave Plus Dimmer Driver The new GE Enbrighten devices are just different enough from the old that I wanted to make a new driver that supported the features correctly. NOTE: This is for the toggle/paddle GE Enbrighten Z-Wave Plus Dimmers only (ZW3010 / 46203 / 46564). It will not work with any non Z-Wave Plus GE models (12xxx), it will not work correctly with any other Z-Wave Plus GE models (14xxx). Features: ON/OFF/Level Can set default ON %, both by a parameter setting and …

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled