UltraPro, 700 Series

I spent the morning with this, and I think changing parameters on the fly with your driver can do it.

As in the past, have to be careful with the Configure command, but actions could bring it back to where it should be, I suppose.

In testing, I made a double tap on the switch control one virtual switch and a triple tap another virtual switch. These corresponded to motion lockouts.

I used parameter 3, varying between 2, "always on" and 3, "always off", and parameter 34 with 4 being 'green' and 5 'blue'.

The double tap was green and the triple tap blue. Worked.

However, it exposed the limitation that you don't know what's actually on, since both of them could be on! Perhaps cycling between the two colors? Hours of fun, lol.

I might try to swap them (4 switches) with switches that could benefit from the colors. More work, but perhaps worth it, to some small degree.