Only one of those "ghosts" was a mesh node. The others were LR.
I suspect most of your issues (including the LR ghosts) would be solved by doing a hub shut down, pull power for 30 seconds ands boot back up. You might just have too much going at once once and locked up the radio.
I assume you have followed these instructions? [APP] SmartStart Manager for Z-Wave (Long Range support) - #2 by jtp10181
What is your power source for the Hub? Make sure yo use a standard USB-A supply with at least 1A (2A for Pro) output for all testing. Once devices are working you can try alternate power sources if you want.
- Any "Pending" devices in SS I would disable all of them in my app.
- Any not paired devices, power them off.
- Shut down hub, pull power for 30 seconds and restart.
- When hub comes back up, try to exclude one of the problem devices.
- if not excluding try a factory reset on the device instead.
- If that works then power it back off again.
- Enable SS entry for that device, then from there follow my other instructions.
