Hi all,
With the heating seasons almost finish (maybe already finish for some of you). I was having fun by updating the driver on my side this winter. By making some tests, I've realized that the thermostats already have a built-in energy meter, so the energy value do not need to be calculated at the hub level. By doing so, the power value does not need to be read very often to have a good precision on the energy. This considerable reduce the load for the hub if you have several of those thermostats.
Moreover, I've put some (I believe) enhancement in the driver. I was having (but rarely) some thermostats that was not receiving the setpoint. Now, as long the hub does not receive a feedback from the thermostat when changing the setpoint, the setpoint is resend every 30 seconds. Since this implementation, all my thermostats follow perfectly my schedule/commands.
Moreover, I've programmed a slight delay (2 sec) on the setpoint. This make the dashboard tile respond much better.
This new driver can be found here:
Take time to read the Readme regarding this driver 
:
