Send Zwave Command

[JasonJoel]

How to use Advanced->Send Zwave command

I am suspecting my device has a low battery even though they were wrapped and unused. It supports "Command_Class_Battery" according to the included leaflet. Currently I have it using Generic Z-Wave Motion Sensor. Can someone advise how to put in a command to have it report its battery status to me?

https://sdomembers.z-wavealliance.org/document/dl/638

https://sdomembers.z-wavealliance.org/document/dl/917

This is the spreadsheet I was referring to:
https://sdomembers.z-wavealliance.org/document/dl/823

And a good example from @jtp10181 himself using PC Controller to figure it out:

Z wave command

OP inquiry is related to this post which has a little more info: [RELEASE] Z-Wave Universal Device Scanner - #4 by gettimhere From the device page under the Advanced send zwave command you have to just send the full hex string for the command, nothing else. I like to work it up in PC Controller and copy/paste. Give me a minute. I think this will do it 87 01 00 01 0D 01 64 Here is how I got it. [image]

Enjoy!