As an experiment, I switched my Ikea Tradfri Signal Repeat driver to community created Zigbee - Generic Repeater (with Presence) for the additional capabilities. It didn't really do anything for me so I have switched back to the built-in Ikea Tradfri Signal Repeater. Now I am getting the following in my logs.
That driver doesn't have Configure as an option to push after switching drivers so I then switched to Device driver, hit Configure, then switched back to correct built-in driver but am still getting errors.
I had to use Markus cleaner tool when I did a similar thing with his drivers. They are very persistent, and clearing these using the tool was the only thing that worked. It was on his Github, but I am not sure where to find it now.
It does not but your suggestion inspired me to go back to Community driver and see what I can turn off there because I hadn't do so previously. I disabled the presence detection and check in then saw a Stop Schedules command button so I pushed that too. Then, switched back to the built-in driver. It's only been a few minutes but so far so good. Thank you.
Actually, it does - but I proibably didn't explain it well enough. This is the command I was thinking of. You get this when you change the device type to "device". The "device" type is handy for clearing out jobs or child devices that are left over from other drivers.