[Request] Update Z-Wave discovery for Jasco Z-Wave Switches to choose correct driver

[danabw]

@user1863

The Honeywell switches

If these are Z-Wave Plus Honeywell switches/dimmers I would highly recommend you use these drivers...the drivers say "GE" but Jasco GE/Honeywell/UltraPro dimmers/switches all use the same driver. The drivers enable up to 6 virtual buttons on the switches (tap, double tap, triple tap), and can speed up status reporting.

Dimmer:

[RELEASE] GE 4xxxx / ZW3010 Enbrighten Z-Wave Plus Dimmer Driver

GE Enbrighten Z-Wave Plus Dimmer Driver The new GE Enbrighten devices are just different enough from the old that I wanted to make a new driver that supported the features correctly. NOTE: This is for the toggle/paddle GE Enbrighten Z-Wave Plus Dimmers only (ZW3010 / 46203 / 46564). It will not work with any non Z-Wave Plus GE models (12xxx), it will not work correctly with any other Z-Wave Plus GE models (14xxx). Features: ON/OFF/Level Can set default ON %, both by a parameter setting and …

Switch:

[RELEASE] GE 4xxxx / ZW4008 Enbrighten Z-Wave Plus Switch Driver

GE Enbrighten Z-Wave Plus Switch Driver The new GE Enbrighten devices are just different enough from the old that I wanted to make a new driver that supported the features correctly. NOTE: This driver is designed to work with the 4xxxx series GE Enbrighten Z-Wave Plus Switches only. It will not work with any non Z-Wave Plus GE models (12xxx), it will not work correctly with any other Z-Wave Plus GE models (14xxx). Features: ON/OFF Support for button events: Single Tap Up = Button 1 Single …

Read the first post in each thread for info/advice about settings.

@user1863

have a Schlage Z-Wave (not plus) lock that I am going to have to deal with - and I am pretty scared at the moment.

See my post in this thread here for specific instructions on pairing the Schlage. I have the same lock, non-Plus Z-Wave, and it works perfectly on HE.

Add the lock to your hub last, after you have added all other Z-Wave devices, and ensure you have beaming repeaters (Z-Wave light switches, Z-Wave repeaters) between your lock and your hub.

First Days Migrating from Wink to Hubitat, Successes, Failures, and Solutions to Help Others…

I have an old Z-Wave Schlage lock, BE469 I got in 2016. I've connected it to both SmartThings and Hubitat hub and it's stayed connected and run w/out issues for the last 7 years. I believe that is part of your problem, doing the lock first. Try the following: Pair the lock last, after you've built a strong Z-Wave mesh, including beaming repeaters like Z-Wave switches near the lock. You don't rely on those repeaters for initial pairing, but you want them there/available as soon as the lock i…