what are the reporting options for temp and humidity?
3041 or 3045 and whats the diff?
i also like usb since i have the plug there and its one less thing i have to remember to swap batteries before going to our other house for 4-5 months.. and one less thing to die if i forget
also the ones i am seeing are not aaa but cr2 what model is yours.. i dont want moer cr2
https://www.amazon.com/dp/B00X871DB2/ref=cm_sw_r_cp_apap_1GcIeRtoZOm15
Long Battery Life (up to 5 years),
thanks yous must be the ceiling one with 2 aa batteries. dont think that is going to work for me as there is a large heater celing fan in center of bath.
I don't have any directly over the bath and the all work fine. On of them is just leaning against the wall by my sink in the master.
not impressed with the nyce sensor.. first one will not report temp with any frequency.. once the temp is not changing much it doesnt report it till there is motion then suddenly there is a big change, so obviously its not reporting.
got a replacement and this once is not reporting humidity changes.. ran a shower other one went up to 57% as it should,. the new one stays at 33% checked till there was motion then suddenly jumped to 42 but still too low.
they are mounted right next to each other
guess i can keep one for temp and one for humidity.. lol .. i dont think so .. too expensive..
motion works the same on both.
old one working for humidity but not temp.. look at the time between temp reports
new one working for temp, but not humidity
what driver are you using.. my driver built in nyce does not have those options..
that is probably my issue
Using the built-in... You got the ceiling mount ones right? Those are the ones I have.
THe 3043 are ceiling mount with tripple a batteries. I don't know about the other model.
no i have the wall mount one.. but why would the options in the driver be different.. i guess that is a problem with the driver..
No telling. The ceiling ones have been great for me.
ya the specs are the same on their website the docs reference both in the zigbee spec.. but i cannot find the config commands.. i did find some documentation on smartthings and an old device handler i am now just porting.. with two extra parameters minimumreport time and maximum report time.
I cannot find any reference as to how to set the reporting amount anywhere..
What platform are you running on your Hubitat?
Temperature / Humidity options on Nyce sensors were added in 2.2.4 - Release 2.2.4 Available
1 Like
Just to let you know, I have the aeon multisensor 6 on usb power and indeed, the defaults are quite chatty.
However, all of the reporting can be set via parameters, and now I'm only getting them once am hour unless there's a significant change.
It did take some fiddling with the drivers because some parameters are sent again after you send the configure command, but now everything is perfect for me.
thanks that the issue. oh well will have to wait to 2.2.5 as the battery spamming issue killed all my ecolink sensors and one motion in 2.2.4
Just use the ring alarm contact sensor driver. It works fine in 224 for the ecolinks.
that wont work as i also had trouble with two of my ecolink motion sensors..
1 Like
hoping for 2.2.5 with all the battery device drivers fixed soon.
1 Like
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.
