Random ZB joins

[brad]

I am getting these as well and have no idea from where they are coming. Another post about this here:

Zigbee Pairing: The device join failed and was not added to your network. Make sure the device is compatible before trying to pair the device again

@mike.maxwell I have a Linptech Presence Sensor that falls off my C8 Pro zigbee mesh from time to time. When this happens I put the hub into Zigbee pairing mode and reset the Linptech device so it pairs and falls back into place. The past few times I went through these steps, I get the following errors in the log even though the device re-pairs successfully. [image]

@mike.maxwell - Any idea what's going on or how to fix it? No unpaired devices show up on a general pair. Thanks