Random ZB joins

[dnickel]

C8 2.3.9.174
I don't think this is a beta issue so posting here in the general assembly.
Lately, after my ZB crash and rebuild a few weeks ago, I get these random alerts of a ZB join failed.
That's fine if I was actually joining a device but this just comes out of nowhere.
Got this last night and this morning:

sys:12024-08-27 08:04:24.873errorThe device join failed and was not added to your network. Make sure the device is compatible before trying to pair the device again.

sys:12024-08-27 08:04:24.862errorThe device join failed and was not added to your network. Make sure the device is compatible before trying to pair the device again.

[brad]

I am getting these as well and have no idea from where they are coming. Another post about this here:

Zigbee Pairing: The device join failed and was not added to your network. Make sure the device is compatible before trying to pair the device again

@mike.maxwell I have a Linptech Presence Sensor that falls off my C8 Pro zigbee mesh from time to time. When this happens I put the hub into Zigbee pairing mode and reset the Linptech device so it pairs and falls back into place. The past few times I went through these steps, I get the following errors in the log even though the device re-pairs successfully. [image]

@mike.maxwell - Any idea what's going on or how to fix it? No unpaired devices show up on a general pair. Thanks

[mike.maxwell]

These are rejoin requests from a zigbee device, I don't think its from the Linptech sensor as I've had one running in dev for months now and haven't seen this error.
Are you sure it's this sensor producing these?

[dnickel]

I increased my ZB power level to 12 from 8, did a Network Rebuild. and got this in the logs * 12

sys:12024-09-01 20:29:02.523errorThe device join failed and was not added to your network. Make sure the device is compatible before trying to pair the device again.

[brad]

No, in my case, I have no idea what it is. I don’t have any Linptech devices.