Hi, Need help for showing motion status. I just added a new Ecolink Z wave PIR 2.5 Motion Sensor. However, the device details only shows battery 100% and temper state, but no motion field at all. I excluded and re-added. Still same thing. No motion reported at all. Do I need a special driver fo…

Try hitting the "Configure" button on the device page.

[image] Eric.C.Miller: Try hitting the "Configure" button on the device page. It doesn't work. No motion detected.

[image] roger89: It doesn't work. No motion detected. The log sees that the motion sensor sent the motion "Active" to hub, but device status doesn't show Active.

[image] Eric.C.Miller: Try hitting the "Configure" button on the device page. The log sees that the motion sensor sent the motion "Active" to hub, but device status doesn't show Active.

I can confirm that is the correct driver. I have a couple of them and the Generic Z-Wave Motion Sensor is the driver that I am using. Just curious.......does anything show up in the Events log on the device page? Edit....also you do need to remember that the Ecolink has a 4 minute retrigger tim…

[image] Sakman: Just curious.......does anything show up in the Events log on the device page? Edit....also you do need to remember that the Ecolink has a 4 minute retrigger time. so you need to leave it alone for 4 minutes before you try to retrigger it. The events are very not accurate. I…

Maybe not a Hubitat hub issue but a Hubitat Z-wave mesh issue. Can you try moving the motion sensor around to other locations to see if its operation improves? You might need to add a repeater to get it to work in the location you want. Another suggestion is to post a copy of your z-wave details…

[image] Sakman: an you try moving the motion sensor around to other locations to see if its operation improves? You might need to add a repeater to get it to work in the location you want. Ok. I think you are correct. It does look like the distance issue even the motion sensor is 45 feet fro…

If you are seeing a log entry showing "Active" for this device, that would be coming from the hub. Log: [image] Are you also seeing the Active report on the Events tab? [image] But you don't see an "Motion: Active/Inactive" on the device page . . . [image] Very odd. Mine is pretty old - if …

No Motion Status for New Ecolink Z Wave Motion Sensor

Get Help

Sakman September 9, 2022, 12:01am 12