If a device supports the configuration command class and you randomly try drivers meant for other devices you could end up temporarily breaking the device.
Assuming the configuration parameter that was changed is documented you might be able to fix it by playing around with the settings, but if not you'll have to remove the device and factory reset it.
The chances of that happening are low, but if you have a device being used in a lot of automations it's probably not worth the risk.
That disclaimer is completely unrelated to the ZSE29, but I want to make sure that new users are aware that it's not completely safe to try drivers that were written specifically for a different device.
I'll add the new settings to the ST handler this weekend, but in the meantime you can use the driver below to change those settings and then switch back to the generic z-wave motion sensor driver.
I don't believe that generic driver blindly changes configuration parameter values so any changes you make with the driver below should stick.
