Hello all and thanks @guyeeba for the driver.
I am using LLKZMK11LM device to power traveller lines to feed mechanical switches so i can control my lights with my existing mechanical switches.
My existing switches are 3way and with @guyeeba driver i can operate my lights.
(For this setup one of the two traveller lines should always be powered and state changes when toggling).
My problem is when the LLKZMK11LM device is powered up although it remembers the state of L1 ,L2 and it turns on the proper one , after a second it switches both L1 and L2 to off.
Although power outage is not very often where i live, it is possible to happen and I would like the aqara relay to maintain power on L1 or L2 during startup.
I don't know if this behavior comes from the relay or the hubitat driver (during power up) as I only paired it with hubitat (don't even own an aqara hub).
I would appreciate your help as if there is a line somewhere in the driver that I could change to make this happen or with any other of your suggestions.
Download the Hubitat app
