Leviton 800 Series ZW6HD Dimmer Driver

[dennypage]

@jtp10181

Not sure if doubletap up is supposed to make it 100% but it does work, sort of. Light will go to 100% but then the devices reports 100 and then the prior level right after, so hub shows the prior level. Same happens if I then turn it off and on again, it will report 100 then flip back to prior level (light stays at 100).

This sounds like a bug from the early firmware, resolved some time ago. Check the firmware version. I believe the current firmware is ZW6HD_v1.1.0.9_1.