Anyone else finding that sometimes this thing reports the wrong status?
Not sure if doubletap up is supposed to make it 100% but it does work, sort of. Light will go to 100% but then the devices reports 100 and then the prior level right after, so hub shows the prior level. Same happens if I then turn it off and on again, it will report 100 then flip back to prior level (light stays at 100).
Also, it is reporting an actual 100 level, which is outside of z-wave specs.. 
full brightness should be 99 per specs.
Buggy firmware it looks like to me.
At one point I had it telling level was 0 after right I turned it on also, not sure how I got it like that but I cant seem to make it do that again now. Anyone else having it stuck showing "off" after you turn it on? It might flip to on quick then back to off (but light stays on).
