Looks like you maybe tried to pair the lock without security once, which for sure wont work.
Use SmartStart.
You can try to remove those ghost nodes using the built in hub tools, instructions are here: How To Remove Ghosts using hub tools or a UZB Stick
Seems like you may need to do this before you go any further. If its going into that busy state right after booting up, something is spamming the mesh. Do you still have the batteries in the lock(s)?
- First factory reset the lock, you can also exclude but after that I would factory reset it.
- Pull lock batteries.
- Add device to SmartStart using the mobile app. Do not change the security settings.
- Shut down hub and unplug for 30 seconds, boot back up.
- Open logs in a new tab.
- Power up the lock.
- You should see a log message about SmartStart join started, and then 30-60 seconds later it should start the pairing process (lots of logs).
- If it does not start pairing on its own, manually put the device into inclusion mode. You should not need to start inclusion on the hub when using SmartStart.
