Yesterday I unboxed and setup my controller. I am making the switch from a Vera Plus. I unpaired six Fibaro flood sensors FGFS-101-USA-A-v1.00 and was able to pair them successfully. In Basic Rules I made a scene that says when water is detected then turn ON a switch. The problem I am having is tha…

Still no joy getting my Fibaro flood sensors to work. I have excluded them from the controller as well as performed a factory reset. I then paired a sensor back into "devices" but still it does not appear to be working. Sensor shows "dry" even when I subject it to water.....uggggg! Two questions: …

Ignore the rule for now - start by checking if the device is working. E.g., does the device page show wet? What events are shown on the events tab? Once you know the device is working, then we'll look at the rule to see if that has a problem. Post a screenshot of the device page. (since you are new…

Thank you for your assistance. Device page shows "dry" as the current state. When I put the sensor into water, the audible alarm on the sensor sounds but the device page still shows "dry". [image]

On device info tab, what is the type? That's the driver it's currently using.

It's a Fibaro Flood Sensor... [image]

Well that looks right. I do not use this sensor but I have several leak sensors in my system. As @jlv mentioned if your sensor is not updating on the device page then the rule isn't going to work. You mentioned you had 6 sensors, so is it just this one or are all your sensors not working? Seems …

[image] terminal3: Seems like you have a Zwave signal issue. For some more info on Z-Wave diagnosis check this thread: [image] bangbang READ FIRST - Before Posting in Get Help Get Help Welcome to the Hubitat Community. You are probably reading this…

That's correct.... all 6 sensors when wet do not change from "dry" to "wet". As mentioned, they all worked prior to removing them from the veraplus controller. I did excluded them and then installed on the Habitat.

Here's a screen shot of one of the sensors..... [image]

I think the lack of a 0x5E in cluster means you have a non-plus device. :thinking: Depending on the version of Hubitat hub you have that may be a problem.

I'm not sure what "the lack of a 0x5E cluster" means but I'm sure the sensor is a non-plus device since the date on the box is 2016. I guess I will have to get some updated flood sensors. Can you recommend a source to buy them? I'll probably need other sensors so a good supplier would be beneficial…