Hubitat-QolSysIQPanel see contacts but no commands

[JumpJump]

This post should be merged with this thread:

[RELEASE] QolSys IQ Alarm Panel Drivers

This is a set of drivers for the QolSys IQ2, IQ2+ and IQ4 alarm panels. Update: This driver works with the IQ4 panel, but you must be running firmware 4.1.0 or later. Also, if you want to arm/disarm through HE, you must leave six-digit codes enabled on the IQ4. With these drivers you can: Monitor the state of any device connected to your alarm system Monitor the state of the alarm system itself Arm and disarm the alarm system Initiate an alarm condition Change HE modes automatically when th…