For the Zooz 4 in 1 ZSE40 sensor see my tips here: [DRIVER] Zooz Sensors Advanced (ZSE40 / ZSE44)
If you do not have the ability to use a secondary controller to change the security, there are two ways to reduce the amount of traffic from that sensor and keep it S0. I assume your ZSE40 is node 0x28 based on the info shown.
For the original ZSE40 (500 series) I would HIGHLY recommend changing Parameter 8 to "Notification Reports Only". -- This will halve the number of reports sent for motion.
And then this:
NOTE: The ZSE40 v2 with 500 chip has a final firmware update to 32.12 that can be requested from Zooz. This sends alerts to the hub at the start and end of active motion only. The repeated alerts every 8 seconds was removed. This will greatly cut down on excessive z-wave traffic.
