I am a little too busy to get into ESP boards and would like to use a Thin Film Force Sense Resistor.
I have it hooked directly up to the contact sensor and it closes too easily.
What ohm resistor should I put inline to put more weight on it before it trips/closes?
2 Likes
Check out this thread from @ogiewon that uses FSRs:
2 Likes
The reason I didn't want to post on that thread is the fact that he is talking about Arduino. I
t's also impolite to 'thread-jack'. Plus, I know he hates thread-jacking from other threads that he's started and went off topic just a little bit.
aaiyar
4
I think @ritchierich meant to check out that thread for the resistance of inline resistors used.
1 Like
I have and didn't see any mention of a separate [inline] resistor.
aaiyar
6
To be fair, he's using a board with that, not a contact sensor dry-wired
system
Closed
8
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.