Why does my C8 keep freezing up. I’m on version 2.4.3.137, updating to current (2.4.3.171) now. But I don’t have high hopes for improvement after reading the change notices. It will run fine for a few days, sometimes weeks. Then locks up…can’t access through the app and the programmed automation…

I also have a C8 and after awhile i need to reboot the hub. Mine doesnt freeze up or anything like that but it will start to get slow. And what i mean by that is the automations start getting slow. Ex if i walk into a room motion turns on the lights sometimes that will have 5 or 6 seconds. But after…

Normally when I hear “slow hub” I look at the available memory - usually reboot if it falls below 180MB but should be viable down to 120MB. If memory drops low enough the hub will stop responding, i.e “freeze”. Change of IP address when the DHCP lease expires will also cause a loss of the ability …

Still having issues. Got home and the automation hadn’t run….Hubitat was unreachable via the app. This was before when the log shows an error (that was about the time I power cycled the device). [image]

Did you try any of the things from the post neonturbo linked above? In your latest screenshot, I don't know what that error means or if it's even relevant to any of this, but one clue that may help there is identifying its source -- what app is "app:9"? You can hover over that label in the logs to…

Thanks for the responce! I did try the things linked above. The diagnostic tool didn't really have any diagnostic tools....just different resets and a check that the time was set correctly (it was/is). Maybe I should try running in safe mode? When I hover over app:9, it's the name of my hub setu…

"Huber Home" isn't your hub, at least officially... Your hub is the "Hub" entry just to the left of "Huber Home". Huber Home's error message may have nothing to do with any of this, but it's still probably worthwhile identifying what app that actually is.

[image] I saw "Hub" but this appears to be the name of it. I don't know what the logical difference is between app:9 HuberHome and sys:1 Hub.

"Hub" is always what the hub's logging entries are under in the Logs - it doesn't use any custom name there. Plus, it's "Huber Home" with a space in the logs, but your custom hub name (HuberHome) doesn't have a space. sys:1 Hub is always going to be what the hub sends logging events under. app:9 Hu…

[image] hydro311: app:9 Huber Home is some app that you installed and gave that name "Huber Home" to. Search your apps list Click on the link in the logs Something should get you to the correct app entry so you can see what it is.

Freezing up - problem solved

Get Help

neonturbo December 17, 2025, 3:59am 2

There are a few things in the link below you probably should check or perform. You also probably should submit any logs or other relevant information from this list.