Fibaro FGK-10x driver w/temp

[Arek]

Fibaro FGK-101 reports state change in debug but otherwise nothing

I figured out a way to this from within the Hubitat user interface. If you open a Z-Wave device in the admin portal there is an un-conspicuous looking button named Advanced. If you click on that you will see a prompt from where you can send arbitrary Z-Wave commands to the device. If you enter 85 01 03 01 and click the send button (make sure the sensor is awake) it will add the hub (Node 1) to association group 3. This should in turn cause the sensor to send sensor reports and, if available, t…