Well I sure would like to know how to make mine report like that
I'm not sure what firmware I have on all mine.... That may have something to do with it? They all pretty much look like this
This is my data section:
wake up interval is the same (12 hours) but it does not work on mine.
edit: I waked up the device and did a save on it. There was a configure entry in the log. So maybe it will fix the problem.
Somewhat OT but does anyone know if this works outside the US? Are smoke detector siren beeps/tones the same globally?
Unless something's changed, Mike couldn't get the zigbee version to function as intended and wasn't planning to look into it further.
1 Like
I looked into that a while back. Unfortunately they’re not.
2 Likes
The pattern is dictated by standards developed by UL, so I wouldn't expect device manufacturers outside of North America to adhere to it.
2 Likes
Bummer, thanks guys. Much as I'd like to test this, don't really want to drop $50 on a potential brick. (obviously I've run out of stuff to connect to my HA system!)
1 Like
Do your smoke detectors sound like this? Post earlier in this thread by @jtp10181 includes a link to the UL-standardized alert tone pattern.
2 Likes
Thanks for the link. The tone sounds similar. I'll have to trigger mine later (not pleasant) to see if its a 3 beep repeat with the same beep frequency.
2 Likes
Automatically reports Battery and Temp on mine as well (the Smoke and CO clear was due my monthly Smoke/CO detector testing):
I get a report based on Device Monitor checking for last Activity so that if it does not report within a certain time interval, a Push Notification is sent and Echo Speaks announces that the Firefighter has lost its connection or if battery level is below a certain % (not sure how accurate the battery level is though since I have not tested the failure level in RL).
14 hours later, still no report 
Odd. Mine is reporting every 12 hours if not a little more often if you include temp.
My data section looks identical to yours except the zwNNUR number, and mine matches @rlithgow1 . I have no idea what that indicates, if anything.
1 Like
My data section is different also - from yours and @ymerj’s. FWIW, here’s what it looks like:
1 Like
They all look identical except for the zwNNUR which, for me was 13 yesterday and become 2 after the manual wakeup.
I'll try exclude and reinclude to see if change something
1 Like
I'd do a full factory reset too for giggles..
1 Like
Hmm I don't have the msr or manufacturer data. Also what is zwnnur anyway?
ZWave Node Neighbor Update Request. AFAIK, in a stable network that should not change too much.
1 Like
I did an exclusion then a factory reset as @rlithgow1 suggested and included it again, all following ecolink instructions. It still does not report unless I open the case or do a smoke detector test.
So I don't know what I am doing wrong
