Assigned to a Minoston Dimmer Plug (MP21ZD) just now and things seem to work normally, no issues controling the light from the Device page or automations. Nice work!
During initial setup, I hit Configure and then Refresh, sync completed and then prompt appeared w/something like "Refresh the page and then Save." Since I had just done a command Refresh I assumed that "refresh the page" meant reload the page, so did that, and then since the only "Save" option is on the Preferences page, went there and did a Save (though didn't change any of the default settings).
Wanted to post logs as had a couple of Error messages during the driver's initial configuration. I think those are due to the fact that the plug is included w/out security, no S2.
