Checking the code of a driver

[MihaK]

is there a way to peek into Groovy code of built-in drivers?

I got a zwave Zooz tilt/shock XS sensor thinking that it will return an angle of a tilt, not just [open/close] binary value. Zwave inclusion detects it fine and uses a built-in driver (Zooz ZSE43 Tilt Shock XS Sensor) - but it doesn't return an angle value.

Can I check how driver is written and decide if I need to rewrite what driver returns to HE, or is sensor itself returning a binary value that is then just passed on through driver to HE?

[csteele]

The only code that Hubitat releases is found at:

GitHub - hubitat/HubitatPublic

and the tilt sensor common definition is a contact sensor, as I answered in your other question.

[MihaK]

yeah, not according to the thread that I linked there too...

Do tilt sensors send the tilt angle?

I googled around but was unable to find out - do tilt sensors like the Ecolink garage door tilt sensor send the angle of tilt? I have an older model Litter Robot (cat litterbox in which a globe rotates and dumps waste in a container) that occasionally gets stuck partway through a rotation. If it gets stuck, power cycling it will get it moving again so I was thinking of attaching a tilt sensor to it and writing a rule like 'if tilt angle is not 0 for more than 1 hour, turn the power outlet off a…

[aaiyar]

@MihaK

I got a zwave Zooz tilt/shock XS sensor thinking that it will return an angle of a tilt

Wherever did you get this idea? The product page clearly indicates it only returns open/close. There are a few zigbee tilt vibration sensors that can report xyz angle/position.

[MihaK]

Lack of research and blind assumptions, I guess...