C7 Stops running automations and will not work zWave devices

[bill.d]

@methyl.mercury

This worked for all but 2 Zooz motion sensors which are listed at S0 now.

Are these ZSE40 4-in-1 battery powered sensors? If so, S0 will run the batteries down very quickly and then in their dying process will stop working reliably and will adversely affect your mesh. These sensors need to be paired unsecurely, but that that is only possible by using a secondary Z-Wave controller and PC Controller software.

Zooz 4-in-1 (ZSE40), C7, S0

I’m not sure I came through clearly. The lack of prevention of S0 bootstrapping is a limitation of the current specifications imposed by Silicon Labs and Z-Wave Alliance on 700 series hubs, this was not a decision made by Hubitat.