[Android 2.0 build 212] HSM controls do not work

[jlv]

I first noticed this in build 210.

If I select the HSM setting on the home page, it opens a page with 5 HSM actions (to arm). But non of the actions do anything.

Further, the current arming state shown on this page is "Disarmed", when my system is currently armed.

I tried to set it to Armed Away, but I was unable to do so in the app. I had to use my old dashboard I had for HSM to arm it. When I did arm it from my dashboard, the arming state on the home page didn't update. That was done running build 210 this afternoon. When I installed 212 just now, I noticed the arm state on the home page is now correct, but still wrong on the HSM page.

[bobbyD]

@jlv

select the HSM setting on the home page, it opens a page with 5 HSM actions (to arm). But non of the actions do anything

The HSM features are still under development, though arming/disarming commands work. The feedback that a command was sent to the hub is not obvious at all. That will be addressed in a future update.

[bobbyD]

@jlv

select the HSM setting on the home page, it opens a page with 5 HSM actions (to arm). But non of the actions do anything.

Check out the update 218:

[Android Mobile App Beta 2.0] What’s new in build 218

See this post for the initial release: [BETA RELEASE] New Hubitat Mobile App available in Google Play for Android (version 2.0) *Customs modes now supported *HSM improvements on home and HSM screen *Geofence settings fixed.