Not sure if I should start a new thread, or tag on here.
I have installed the @tomw Aladdin driver following the steps on the github driver page. My single door now shows up a a child in the Devices page. When I open the child device, the "door" in the status section DOES change when the door goes up/down. But the two command buttons "Close" and "Open" do not activate the door. This was my first check to be able to get this to work manually before I began adding rules/automations. Also I put this device on a dashboard (again with instructions from the github driver page) but it doesn't work there. Any suggestions for troubleshooting to get the manual "Close" and "Open" buttons working?
Download the Hubitat app
