Zwave repeater error

NoWon · October 9, 2018, 7:11pm

@mike.maxwell
I found the problem
I had just redone all my rules to rule machine 2.5
I created a virtual refresh button and had a refresh devices every 12 hours or when the button was pushed rule. The problem was I also assigned the virtual button in the refresh rule action Assign Buttons . (So the virtual refresh button would not go stale in the device status).
Which then caused the loop.
Should have just had the refresh 12 hour rule select the virtual refresh button and left it out of the refreshed devices.
I am an idiot

Rxich · October 17, 2018, 2:55pm

Hi Guys, my apologies if this has been already stated. I've found this handler to be extremely helpful in determining if my 3210-L are actively repeating Z-wave in my deprecated ST world.
Wonder if it could help now with hubitat. Just fired up my "tat" last night !

github.com

shackrat/SmartThings-by-Shackrat/blob/master/devicetypes/shackrat/iris-zwave-repeater.src/iris-zwave-repeater.groovy

/**
 *  Copyright 2017 Steve White
 *
 *  Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
 *  in compliance with the License. You may obtain a copy of the License at:
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 *  Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
 *  on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
 *  for the specific language governing permissions and limitations under the License.
 *
 */
metadata
{
	definition (name: "Iris Z-Wave Repeater", namespace: "shackrat", author: "Steve White")
	{
		capability "Health Check"
		capability "Polling"
		capability "Refresh"

This file has been truncated. show original