I have an old CADDX NX-8 Alarm Panel. Working perfectly for 25 years. I have been using a Konnected system to integrate my Alarm Panel to Hubitat. However, my Konnected system did not make it through the migration to my new C8 Pro Hub. It is old and the software won't update. Rather than buying…

I use a Fibaro Smart Implant in my HW panel to arm, read arm status, monitor alarm and set siren off if need be thru a 24 hr zone. I do not think you can find them anymore however I have a Zooz Zen17 set up ready to put in the panel if need be. Just have not wired into the panel and checked yet but …

I'd recommend the Ecolink. Old tech, but good. https://www.homecontrols.com/Ecolink-Z-Wave-Plus-Door-Window-Sensor-Gen5-ECDWZWAVE25ECO

This device is magnetically operated. Does it also have terminal inputs for my alarm panel outputs?

You can use any leak sensor as a dry contact sensor. If you buy one that has a cable and a probe, you can save soldiering wires to the contacts. Just cut off the probe end and wire it directly to your relay. I have a bunch of these Zigbee sensors that I got on Ali Express: [image] There are s…

[image] dean: ZWave Dry Contact Sensor Zooz has a few. ZEN51 maybe? :thinking: [image] [DRIVER] Zooz Relays Advanced (ZEN16, ZEN17, ZEN51, ZEN52) Custom Drivers Zooz Relay Drivers with the goal of exposing all advanced features and settings. If you are using this…

Excuse the dust. It's attached to a temp control at the wood stove. Comes with white and brown covers. [image]

Transfer switch status to Hubitat: [image]

No joy, here. Turns out I have an old Ecolink water sensor. But I believe it just senses Continuity between its 2 leads. Any Continuity and it reports the event. But I am trying to connect this to a DC Alarm Panel output. Turns out that the Alarm Panel outputs even when not activated have a 0.7…

What's the latest on the driver for the new LR Zen17? Last I heard it wasn't ready. Another ZWJS thing. I've got a couple awaiting installation as well.

You may be able to make use of a 12v optocoupler relay between the alarm and the sensor. They usually have a setting to react to low or high incoming voltage, and based on that open or close the other side of the relay. I use one on my alarm where I’m monitoring the 12v siren circuit for voltage -…

ZWave Dry Contact Sensor for Alarm Panel

Get Help Devices

Ranchitat April 3, 2026, 12:15am 5

Zooz has a few.
ZEN51 maybe?