Starting a thread here for the new Zen17 relay ... Mine arrives Saturday, but I probably won't get a chance to play with it till the following weekend (I'm planning to use it for the opener out in my detached garage - hoping current spring weather trend up here in MN holds out for while!) Noticed t…

The next release is always, forever,,, "coming soon." :smiley:

[image] hydro311: coming soon? Very soon

Got it in hand today, but I won't be able to install out in garage for a while due to other stuff going on. Plus, I'd like to wait till official driver release. I'll be using it for a single garage door, and I want to use 2 dry-contact N.O. / type-A reed sensors in hopes to got definite readings fo…

In the same boat, got 3, eagerly waiting for the 2.2.6. Going to use 2 of them for my 2 door garages, replacing the MyQ as the integration with IFTTT became useless with their limit 3 rules. I got MyQ cheap, so that's ok. The other will go to retrofit more sensors of the old security system from …

Woot! Now I know what I'll be doing this weekend - fun times out in the ol' garage!

@bcopeland Hey Bryan. Was just playing with the Zen17 on 2.2.6. Great Device Handler! Quick question on the child devices - Sensor1 and Sensor2. I set them to contact sensor as I will be using them to monitor and confirm if water valves have been closed. (the valves send a ground when close…

[image] Levahj: I set them to contact sensor as I will be using them to monitor and confirm if water valves have been closed. In theory

[image] Levahj: If you can make that change to the device handler it would be appreciated. The options are limited by the firmware options..

[image] Levahj: As a contact sensor it should show 'closed' when the sensor lead is shorted to ground and 'open' when the the circuit is open. You have it the other way around! Wondering if that was on purpose or just an oversight on your side? I would prefer it to show closed when the sensor co…

Hubitat

Zooz Zen17 relay

Get Help

z-wave

bcopeland March 23, 2021, 7:05pm 6

hydro311:

Noticed the page linked above mentions requiring 2.2.6 or higher for Huibitat

Release 2.2.6 Available Release Notes

Hubitat Elevation Platform update 2.2.6 is now available: Please note, the process takes about a minute to download (depending on your Internet connection) and extract the hub update, and 1-2 minutes to perform the update after you click 'Update Hub'. We recommend that you periodically download a backup of your setup from the Settings page, Backup and Restore. Changes from 2.2.5: New Services Hub Protect see this post Remote Admin see this post Drivers and Devices New drivers: Zooz Zen…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled