Zooz Zen16 Multirelay to New Garage Opener

[ritchierich]

@dadarkgtprince

yes. on the garage door button, there's a side button to control the light. you'll need to solder into that button and connect that to a second relay on the ZEN16

Sometimes a picture helps. Here are the areas you need to solder the wires to:

Local Control Options for MyQ Garage Door Openers

I don’t have the after but did take a before because as I get older I am having a hard time seeing up close LOL. With any button you solder on both sides of the button and here is where you solder the wires: [image] And to throw this out there for testing this process, while the button was connected to the GDO, I used a wire and touched these two spots with both ends of the wire and confirmed the light came on. Touched them again and the light turned off. So this validated I had the right …