This valve is working great on my 1" PEX water main.
It shows reversed close/open for me in Hubitat with the generic valve drivers. It also does not expose the built in water sensor yet. Looking forward to the official drivers. Here's a picture and a short video of it in action after triggering the built-in water sensor with some water.
It is a little tricky to get it to open again once it triggers... I had to dry it very thoroughly and blow air through the sensor. I am currently unable to use it with the hubitat safety monitor app using the other new zooz z-wave leak sensors I got, because the safety monitor can only close valves in response to leaks, not open them.
FYI, I was also unable to pair it from my utility room and I had to "calibrate" it on the valve, then uninstall it and move it close to the hub to pair, and then reinstall it on the valve again. It now seems to work fine from the utility room with (reversed) hub control.
I have it plugged into the UPS for my instant water heater for some power failure protection.
