Zigbee pairing with Linkind Motion Sensor (using latest HE firmware)

karsten · February 13, 2021, 8:28pm

The latest supported devices list includes the Linkind Motion Sensor (model ZS1100400) but when attempting to discover/pair the HE sees the device it never gets past “initializing,” so it never gets added as a Generic Zigbee Motion Sensor (no temp) driven device.

Any words of wisdom on getting these to function?

Thanks in advance!

bobbles · February 13, 2021, 8:31pm

I don't know what you need to do to pair this device, but with Xiaomi/Aqara devices, sometimes they do the same thing.
To get round this, when they get in the initialising state I press the button a few times with a couple of seconds gap and this seems to do the trick. I think this causes the device to send its fingerprint again. Not sure though.
Might be worth a try. Good luck.

karsten · February 13, 2021, 8:32pm

Will give it a shot later today and post update.

Thanks

aaiyar · February 13, 2021, 9:13pm

What @bobbles said, and if that doesnt work, try pairing it closer to the Hubitat.

karsten · February 14, 2021, 5:12am

The first pairing always fails. But it does pair on the 2nd go if you start the scan first and then reset the sensor manually.

Thanks for the tips!

system · September 22, 2022, 5:11pm

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.