Zemismart zm85el-2z ( _TZE200_cf1sl3tj ) "specifics" :
- This device does not report the current position during open / close movement, but only when the movement stops. Hence, the preference "Position report timeout" is set for ZM85 to 15,000 milliseconds by default (15 seconds). If your curtains fully open/close timeout is different, adjust this parameter to be 1-2 seconds more than the actual time.
- When the motor is controlled from the up/down buttons on the device itself or from the remote right column 100%(open) and 0%(close) keys, the movement direction and position are not known. The current windowShade state will be shown as "moving". When the movement stops, the windowShade will be determined (open, close or partially open) and the current position should be shown also correctly ( 0%-closed; 100%-opened and in between in 10% steps)
- When the motor is controlled from the remote 70%/50%/30% open position keys (these on the left column) , nothing is sent to HE when the movement starts. The current position and the windowShade state will be updated correctly only when the movement ends.
- SetPosition/SetLevel commands are working OK now ( ZM85 rounds the position to the nearest 10% step)
- Motor direction (forward/reverse) preference is working OK
- StepOpen and StepClose buttons are fixed to 1% (same as from the remote controller).
- Open and Close commands are substituted with setPosition 100/0 for this model.
- Calibration commands for setting the Upper(open) and Lower(close) limits:
Because on HE driver level it is not possible to dynamically filter only these commands that are applicable for the particular device, the Calibrate command list shows also commands for other device types, these must be ignored.
The effect of the "ZM85 Mode Morning" and "ZM85 Mode Night" is unknown ...
ZM85EL-2x "SUPER CURTAIN ROBOT MOTOR" : ) code changes are available in this dev. branch version 3.3.0 2022-12-30 1:43 PM
https://raw.githubusercontent.com/amosyuen/hubitat-zemismart-zigbee/development/Zemismart%20Zigbee%20Blind.groovy
