Logs incoming! I was literally just messing with the lock and taking screenshots. Let me know if you have any questions. For the purposes of this test, all lock/unlock commands are sent via the Device Page.
-
Successful Unlock
-
Intentional Jam Lock. Note the status stays in "unlocked" rather than "unknown" that @jwjr gets.
-
Unlock Command After Jam. The motors actually perform the unlock at this step.
-
Attempt Lock. Unresponsive.
-
Manually Set in "Lock" Position and Remove/Reinsert Battery Pack. The lock beeps after battery pack is reinserted and the lock state changes to "Lock". The lock becomes responsive again.
-
Unlock Command is response again.
I think what I really want to do is send whatever command removing and reinserting the battery pack does whenever there's a jam. It would have been nice if the lock state changed to "unknown" as that can be the trigger for the command, but I suppose a "send lock command but status still equals unlock" can be used.
