Which driver for enbrighten zigbee dimmer/switch?

[aaiyar]

@saurabh9

if only there was a way to configure double taps

There may be - if you do your automations using Node-RED. This post from @erktrek outlines his method for doing so:

Node-Red Flow Samples/Sharing

Because I can't seem to let the whole multi-tap thing go... here is a simple subflow that encapsulates the timed-counter & switch so you can separate single/double/triple/quadruple+ taps after a button press .. Also you set the timing in the properties of the subflow instance node.. default is 450 ms. Note: On my system (C-4) Lutron 5 button picos the 2 & 4 buttons seem to need a bit longer time for multi tap at 700 ms.. [nr369] Not shown on this partial sequence is "Increase" and "Decrease…