Unknown Z-Wave Virtual Nodes

🛎️ Get Help Devices
1

When I was using an Aeotec Z-Stick and Simplicity Studio PC Controller to remove a possible ghost node, I noticed 4 Virtual Nodes (45, 46, 47, 48, see attached) that do not show up on my Hubitat Zwave device list.

Virtual Nodes
Virtual Nodes1022×1422 181 KB

I sent NOP and isFailed commands to each of these nodes without getting any indication of a failure. I suspect that these nodes might have been created during a couple of failed Aeotec Zwave Range Extender device inclusions. Can I exclude these nodes?

2

No.. Virtual nodes are created by the SDK

3

Thanks. I know nodes 2,3,4,5 are created by Hubitat, but does the SDK also create other Virtual nodes?

4

Does the SDK create nodes for a secondary controller…

1 Like