UltraPro ZW4008 LED setup

🧰 Built-In Apps and Drivers
1

I have an SW4008 Ultrapro Switch and right now the LED is OFF when the switch is OFF. I want the opposite behavior (LED is ON when the switch is OFF).

I know these switches are somewhat generic and this may actually be a Jasco, Honeywell, etc. The manual states to hit the top paddle 3 times and then hit the bottom paddle once but that doesn't do anything.

I wouldn't mind using the Basic Z-wave tool but their manual does not include configuration codes and there is no Hubitat driver.

2

Never mind,. I figured it out. The Jasco Manual had the info I needed. I guess UltraPro is identical to Jasco.

3

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.