yes
See:
- If you are using older zwave devices (and some zwave plus devices), these devices may not report physical switch state changes in a timely manner, so you may need to add a refresh in your pistons before checking state for conditions.
- For triggers or conditions, Zwave Poller should be enabled for these older devices. This is due to ST vs. HE differences in handling of older zwave devices. If you choose Zwave poller, you won't need the refresh commands in you pistons:
-
In many cases, replacing these older devices will be your best option to have HE function efficiently and have a well-operating mesh.
-
Device Status Not Updating on Manual Change - #4 by JasonJoelOld
Z-Wave Poller only supports Generic Z-Wave Dimmer and Generic Z-Wave Switch device handlers.
-
- For triggers or conditions, Zwave Poller should be enabled for these older devices. This is due to ST vs. HE differences in handling of older zwave devices. If you choose Zwave poller, you won't need the refresh commands in you pistons:
