[Request] Update Z-Wave discovery for Jasco Z-Wave Switches to choose correct driver

[gravert]

@wwq312

Hi
I think I found a bug while doing Z-Wave inclusion. I have Honeywell Z-Wave light switches(3) that were discovered as "jasco z wave dual outlet". This is not correct.

@mike.maxwell

@wwq312

To fix, I tried to change the Type to be Generic Z-Wave Switch but the child devices were left behind. I added Clean Device and used that to wipe out the erroneous config. Only then I can set to Generic Z-Wave Switch for it to work

we will update the fingerprint in the future to select the correct driver, thanks for the post.

Hi Mike, I am having this exact same issue with Jasco Branded Switches with part number 46562 Ver5.4 on the box.

EDIT: My Hubitat is a C-7 with platform version 2.3.0.119

My Device Data shows similar to wwq312's with the manufacturer being 99 instead of 57, and deviceId: being 12598 instead of 12597

• deviceType: 18770
• inClusters: 0x5E,0x25,0x85,0x59,0x86,0x72,0x55,0x5A,0x73,0x5B,0x9F,0x6C,0x70,0x2C,0x2B,0x22,0x7A
• protocolVersion: 6.04
• hardwareVersion: 255
• firmwareVersion: 5.53
• deviceId: 12598
• manufacturer: 99

Hubitat detects this as a Jasco Z-Wave Dual Outlet and adds two child devices which have to be removed.

I have seven more of these to install. Would love to see this corrected.

Thank you.

On a side note for anyone who has this same switch I found that using the custom device driver from Botched1 (link below) then switching the 'Enable alternate exclusion' to ON then the device reports its state faster on Hubitat. I can't confirm why this works.

https://community.hubitat.com/t/release-ge-4xxxx-zw4008-enbrighten-z-wave-plus-switch-driver/18991